Accessories

Manual Rotary Stage

After hearing our customers say ..."It would be nice if I could just turn the barb myself instead of using a motorized component" ...

Our Manual Rotary Stage design for OASIS 12048 and 12024 units has a double-sided magnetic tab that can be moved between two user-positioned hard stops. The stage’s base has an engraved scale indicating the angular position of the alignment pins and mounting platform. The scale is engraved in 5° intervals, marked every 30° by a number directly over its corresponding tick mark.
The Manual Rotary Stage for the CoreX2 is not engraved but has (4) 8-32 holes that can be used for fixturing. The stage has a double-sided magnetic tab that can be moved between two user-positioned hard stops.

Manual Rotary Stage

Motorized Rotary Stage

With the addition of the new Motorized Rotary Stage, parts can now be rotated a full 360-degrees to get profile images and measurements from every aspect of the part. Of course, all of these measurements are taken in real-time as the part rotates within the field of view.

The OASIS software has been enhanced to work with the new Rotary Stage in two modes of operation:

The first is continuous mode. As with all OASIS measurements, dimensions are displayed in real-time with a traffic-light color coded display panel to easily see the status of all dimensions; Green is pass, Yellow is outside the warning levels, and Red is fail – beyond the specified tolerance limits. The part will continuously rotate on the stage, at a user-defined rotational speed, allowing the operator to view the measurements and status display panel as the part turns.
Second is a fixed duration mode. Within the OASIS part program, the user defines how many rotations for the Rotary Stage to make and how many times to measure the part while rotating. Once the cycle is complete, the OASIS displays the actual measurements of Minimum, Average, Maximum, and Range for every dimension. A single click saves all of the data on the OASIS.

By adding the Rotary Stage to the OASIS, inspectors can insure that their parts are within specification limits all the way around without manually turning the part. In addition, rotating the part adds the ability to check additional features such as roundness and concentricity. With the included software update, all of this additional data is recorded with the built-in OASIS Inspection Report or can be automatically imported into any SPC program.